Fiat X1/9: history and buying advice

Fiat · 1972–1989

Fiat X1/9: history and buying advice

The small Italian mid-engined sports car, styled by Bertone and built from 1972 to 1989.

Nederlandse versie

Fiat X1/9 from 1977
Fiat X1/9 from 1977. Photo: Wikimedia Commons, free licence; author and licence are on that page.

History

The X1/9 began as a show car. In 1969 Bertone showed the Autobianchi Runabout, a study by designer Marcello Gandini. Fiat developed that idea into an affordable two-seater. Fiat only unveiled the car after the Turin motor show in November 1972. At that show the new Fiat 126 was to get all the attention.

The layout was special. The 1290 cc four-cylinder from the Fiat 128 family sat transversely behind the seats and drove the rear wheels. That gave good weight distribution and a car that goes through bends very tidily. The roof panel could be removed, giving you a targa. There were two boots: one at the front and one behind the engine.

Around 1978–1979 came the big update. The 1300 made way for a 1500 with a five-speed gearbox, derived from the Fiat Ritmo. The car got different bumpers and a higher engine cover. For America, heavy bumpers and emission controls arrived from 1975; as a result the American version had less power. Later the American cars got fuel injection.

From 1982 Bertone built the car entirely itself. It was then called the Bertone X1/9. Production ended in 1989, with the ‘Gran Finale’ as the last series. Some 160,000 were built in total; about two thirds went to the United States. The X1/9 also raced, including in a version by Dallara in 1975.

All versions

The X1/9 was built for 17 years: until 1982 by Fiat, after that by Bertone. Tap a version to open it.

Fiat · 1972–1982

X1/9 13001972–1978
Fiat X1/9 from 1973
Fiat X1/9 from 1973. Photo: Wikimedia Commons, free licence; author and licence are on that page.

The first series. A 1290 cc engine with a Weber carburettor, 75 hp and a four-speed gearbox. The first cars had small black bumpers and steel wheels; alloy wheels were available as an accessory.

Recognise it by the low, flat engine cover behind the seats and the slim bumpers.

American 13001974–1978

The 1974 model still closely resembled the European car, with 63 hp. From 1975 the American cars got big impact bumpers and extra emission-control parts. As a result power dropped to 61 hp. Japanese cars had the same specification.

Many X1/9s in the Netherlands come from America. You can tell straight away from the big bumpers.

Special series on the 13001975–1978

Fiat and Bertone launched a series of special editions on the 1300. According to the Italian X1/9 register these included the America (bumpers with a double chrome strip and white leather), the Serie Speciale and Serie Speciale 2 (striping, fog lamps or a different interior) and the America Speciale.

In America there was a Special Edition in 1977 with its own colours and striping. On the wing was a plaque with the Italian flag, a serial number and Nuccio Bertone’s signature.

With a special series, always check that the special parts are still fitted. They are hard to find.

Lido1978
Fiat X1/9 Lido
Fiat X1/9 Lido. Photo: Wikimedia Commons, free licence; author and licence are on that page.

The last special 1300, shortly before the 1500 arrived. Black metallic with thin silver pinstripes, a light Alcantara interior and numbered badges. It was the only X1/9 of that time with chrome bumpers. Around 700 are said to have been built.

A genuine Lido is sought after. Watch out that nobody sells an ordinary 1300 as a Lido; ask about the numbered badge and the original interior.

X1/9 1500 ‘Five Speed’1978/1979–1982
Fiat X1/9 from 1979
Fiat X1/9 from 1979. Photo: Wikimedia Commons, free licence; author and licence are on that page.

The big update. A 1498 cc engine from the Fiat 138 family with 85 hp, a five-speed gearbox from the Fiat Ritmo and electronic ignition. From the outside you can tell by the aluminium bumpers and the higher, black engine cover. The interior and instruments are new too.

The ‘five speed’ badge was on the carburettor cars. For everyday use this is the most pleasant X1/9.

American 1500 with fuel injection1980–1989
American Bertone X1/9 from 1986
American Bertone X1/9 from 1986. Photo: Wikimedia Commons, free licence; author and licence are on that page.

In America the 1500 first had a carburettor with 67 hp. From 1980 in California and from 1981 in the other states it got Bosch L-Jetronic injection, good for 75 hp. For a while those cars wore the ‘fuel injection’ badge.

Bertone · 1982–1989

Bertone X1/91982–1989
X1/9 from 1983, from the Bertone era
X1/9 from 1983, from the Bertone era. Photo: Wikimedia Commons, free licence; author and licence are on that page.

From 1982 Bertone built and sold the car itself, under the name Bertone X1/9. New versions came, such as the IN (1982) and the VS (from 1984), with two-tone sides, leather and alloy wheels. Later years got black bumpers and trim, and at the end sometimes air conditioning. There were also right-hand-drive versions.

Bertone built some 19,500.

Special Edition and Gran Finale1988–1990

At the very end there was one more Special Edition. The Gran Finale was a last variant of it, finished off by the dealer, with a rear spoiler and ‘Gran Finale’ badges. It was the last X1/9 sold new.

Key data

Years1972–1989 (from 1982 as Bertone X1/9)
DesignMarcello Gandini, Bertone
Layouttransverse mid-engine, rear-wheel drive, targa roof, two seats
Engine 13001290 cc four-cylinder, 75 hp, four-speed
Engine 15001498 cc four-cylinder, 85 hp, five-speed (American version with injection: 75 hp)
Weightabout 880 to 920 kg (dry)
Top speedover 170 km/h (1300), about 185 km/h (1500)
Number builtabout 160,000, of which some 19,500 by Bertone

What to check when buying

  • Rust is the biggest risk. Look in the inner wheel arches, the floor, the sills and at the mountings of engine and suspension.
  • Check the pods of the pop-up headlamps; they can rust through too.
  • The bulkheads around the engine are made of three layers of sheet metal. Rust there is hard to see, and a repair sometimes means the engine has to come out.
  • The coolant pipes run from front to back through the body. If they rust through, the car rots from the inside. Ask whether the right coolant has always been used.
  • Ask for proof that the timing belt was replaced on time. If in doubt, do it straight away; the workshop manual gives the interval.
  • If the gear change feels sloppy, the rubbers of the shift mechanism are often worn. If shifting is heavy, there may be damage in the gearbox. Gearbox parts are scarce.
  • The roof panel must fit snugly. If not, new seals are needed, and they are hard to find. Also check that the drains by the roof are not blocked.
  • Interior parts and body panels are hard to get and expensive. So a complete car is worth more than a cheap one with missing parts.
  • Check whether the master cylinder leaks; that is common.
  • Many X1/9s come from America. They have big bumpers and often less power. Check the papers and the condition extra carefully.
  • If you want to drive it a lot, a 1500 with five-speed gearbox is the most practical choice.
To the workshop guide

SourcesWikipedia: Fiat X1/9 (English)Hagerty: Buying guide Fiat X1/9 (English)Registro X1-9: overview of the models (Italian)Italicar: Fiat X1/9 Lido (English)

Looking for parts for this model? See what is on offer on eBay right now.

Parts on eBay ↗Partner link: if you buy through this link, Classic Moto Fix receives a small fee from eBay. You pay nothing extra.

← Back to the homepage